What the 11' Graphite Liner Does
The 11' graphite liner is a replacement feed liner designed for HTP 26080 and 25090 aluminum MIG guns. It allows you to run aluminum wire from 0.030" up to 0.047" through the gun, making it a key component for feeding softer wire without jamming or bird-nesting.
This liner is specifically for use with Pro Pulse 220, Pro Pulse 200, or Revolution 2500 welders when paired with the 26080 or 25090 aluminum gun. If you have a Pro Pulse 300 with a 26100 or 26120 aluminum gun, you need the 12.5' liner (part# 26040-11).
Installation Steps
- Confirm compatibility: Verify your welder and gun model match the supported list: Pro Pulse 220, Pro Pulse 200, or Revolution 2500 with a 26080 or 25090 aluminum MIG gun. If not, contact the seller to find the correct liner.
- Trim the liner to size: The 11' liner will need to be trimmed to fit your specific gun setup. Measure the existing liner or the feed path length, then cut the new liner to match. Use a sharp blade or tubing cutter for a clean edge.
- Install the liner: Feed the trimmed liner into the gun's feed path, ensuring it seats properly at both the wire spool and the contact tip. Avoid kinking the liner during insertion.
- Test wire feed: Run a short length of aluminum wire through the liner to confirm smooth feeding. Adjust trim if the wire catches or binds.
Product Specifications
- 11' Graphite Liner for HTP® 26080 and 25090 Aluminum MIG guns: Graphite liner that can run aluminum wire from 0.030" up to 0.047" wire through. This confirms the liner supports the most common aluminum wire sizes used in MIG welding, so you can match it to your existing wire stock.

11' Graphite Liner for HTP® 26080 and 25090 Aluminum MIG guns - 11' Graphite Liner for HTP® 26080 and 25090 Aluminum MIG guns: If you have a Pro Pulse 220, Pro Pulse 200 or Revolution 2500 with the 26080 or 25090 Aluminum gun please order part# 26040-8. This part number is for the 11' liner; the 12.5' liner (part# 26040-11) is for different guns. Ordering the correct part avoids fit issues.
- 11' Graphite Liner for HTP® 26080 and 25090 Aluminum MIG guns: In each case you will need to trim your liner to size. Trimming is required for both liner lengths, so plan for a cutting step regardless of which model you have.
Checking Compatibility Before You Order
Before purchasing the 11' graphite liner, double-check your welder and gun model. If your setup is not listed (e.g., a different Pro Pulse or Revolution variant), contact the seller at 847-357-0700 to verify which liner works. The catalog notes that the 11' liner is not suitable for 26100 or 26120 guns, which require the 12.5' liner.
Also note that the liner is sold as a standalone part; it does not include installation hardware or instructions beyond trimming. If you need a replacement because the original liner is worn or damaged, this is the correct direct replacement for supported guns.

