MicroCut® 45 DV CNC Cable

The 16-foot length gives me plenty of slack to route it cleanly around my CNC setup, and the plug on the plasma cutter side clicked in perfectly. Wiring the other end took me about twenty minutes, but it’s been running solid since.

Had to wire my own plug on the CNC end, which took a bit of patience, but that 16-foot reach made hooking up the plasma cutter a breeze. The cable feels solid and the connector on the machine side snapped in clean. Exactly what I needed to get my table running.

The 16-foot length was just right to reach from my plasma cutter to the CNC table without any slack. Cable feels durable and the plug side fit snug into the Micro Cut 45. Wiring the other end took a few minutes but the instructions were clear enough.